Following the installation of Vision Flex on your device, if this is the first time you've used the device on your system it will need to be added as a registered device before you can use it.
Registering your device
Find the application on the android device
Start the application
On the bottom left of the screen press the configuration button
Take a note of the Device ID
This is needed in the device for entry in the WMS system.
In Vision Warehousing, open Admin > User Management > 'Flex Devices'Â
Give the device a name, perhaps an asset tag number visible on the device, or the name of the user (only if it's dedicated to a single user).
Enter that 'Device ID' from above
Tick the 'Active' box
Tick 'Voice-Enabled' if users are allowed to use the Flex Voice features on this device (a headset with speaker and microphone are highly recommended)
Click Save
Your device is now ready to be used
Set up a Flex user
This is done in the Warehousing user maintenance screen, Configuration - Users.
Further information can be found here: Flex User Maintenance